DTF Transfers for Hoodies

Plan around the pocket and the hood

The front of a hoodie has less printable space than it looks. The pouch pocket and the hood seam set the limits, so size the front print to sit between them.

• Front print: about 9 to 11 inches wide on adult hoodies, kept above the pocket opening.
• Back print: the back has the most room, so it's the spot for your biggest design.
• Hood and sleeves: small hits like a sleeve logo or hood print work well, but check that the area lies flat on your press.

Getting even pressure

Hoodies are thick, and seams, the pocket and drawstrings can lift the platen off the print. That leaves low-pressure spots where the transfer doesn't bond.

• Use a pressing pillow or pad under the print area so it sits higher than the seams.
• Pull drawstrings out of the way and keep zippers off the platen.
• Pre-press briefly to flatten the fleece and drive out moisture.
• Follow the full pressing instructions.

Hoodie questions

Do DTF transfers work on fleece?

Yes. The surface should be smooth and pressed flat first. Very fuzzy or textured fabric can leave a slightly uneven print, so test one garment before a full run.

Can I put the hoodie and t-shirt sizes on the same sheet?

Yes. Build every size you need on one gang sheet.